2. Horizontal

    According needs and construction condition, digging the hole in horizontal, 0.8-1.2 m in depth, the length according the overall design. The flute will be formed in 200*200mm at bottom, and fight the earth body at the center, stand up the bottom of earth body using small metal mass or steel bar then put on the bleeder agent according the requirement as following.

3. Spots Using Method

    Adding the water to bleeder agent in rate of 2.3/1, fast mixing in the big container around 1~2mins, the dry powder should not be seen from bottom, but not too watery also. Once finished, put into the earth hole immediately (do not put once it has been solidified), then covering the thin soil on top. 5 days later, fill up all the fine soil and tamping it (not over forced).

4. Measurement

1). Once temp filled back, then the bleeder agent can test resistance value. According the time, the resistance might be reduced more.

2). Better using the tested tester with handle, the tester using batteries with button also can be used.

3). Do not measuring in horizontal with horizontal earth, but test in horizontal.

4). If the resistance value performs out of the way ( too big or too small), expecting checking the others (the meter, the connection etc.) the metal around the measuring route also should be checked.

5). For bad soil (such as the soil full of stones) or the narrow place that can not earth, or too high resistance value of the measuring route, should reduce the requirements of resistance pass value, if necessary, can adding the bleeder agent a the supporting place in order to get the real result of the measurement.